Resistance Inspection
WARNING: This page is about a different variant/trim than selected.
NOTE:
- Perform the following procedure only when directed.
- Turn the ignition switch to the LOCK position.
- Disconnect the negative battery cable.
- Remove the fuel delivery pipe. See FUEL INJECTOR REMOVAL/INSTALLATION .
- Disconnect the fuel injector connectors.
- Measure the resistance of the fuel injector using a tester.
- If not as specified, replace the fuel injector. See FUEL INJECTOR REMOVAL/INSTALLATION .
- If as specified but "Operation Test" is failed, carry out the "Circuit Open/Short Inspection". Inspect for open or short circuit.
Fuel injector resistance 1.0-1.2 ohms [20°C {68°F}]