Middle Pipe and Main Silencer Installation Note
WARNING: This page is about a different variant/trim than selected.
NOTE:
- If any the following parts are removed, loosen all the nuts installed between these parts and perform the following procedure: catalytic converter, middle pipe, main silencer.
- Set the middle pipe mount, and temporarily tighten to the catalytic converter.
- Set the left and right main silencer mounts, and temporarily tighten to the middle pipe.
- Completely tighten the installation nuts between the catalytic converter and middle pipe.
Tightening torque
43-60 N.m {4.4-6.1 kgf.m, 32-44 ft.lbf}
- Completely tighten the installation nuts between main silencer and middle pipe in the order of left side, then right side.
Tightening torque
38-51 N.m {3.9-5.2 kgf.m, 29-37 ft.lbf}