LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2006 >> 6 s, 4D Wagon, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 12 (Engine Mechanical [Service Information L3 With TC)) >> Oil Control Valve (OCV) Inspection >> Coil Resistance Inspection

Coil Resistance Inspection

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the negative battery cable.
  2. Disconnect the OCV connector.
  3. Measure the coil resistance between terminals A and B using a tester.
    • If it is not within the specification, replace the OCV.

      Oil control valve resistance 6.9-7.9 ohms [20°C {68°F}] 

  4. Connect the OCV connector.
    Fig 1: Identifying Oil Control Valve Connector Terminals
    G04324485Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals