Inspection Method for Switch Connectors or Wires

WARNING: This page is about a different variant/trim than selected.

Connect the WDS or equivalent to the DLC-2.
Turn the ignition switch to the ON position (Engine off).
NOTE:
- If engine starts and runs, perform the following steps during idle.
Access the PIDs for the switch you are inspecting.
Turn the switch on manually.
Slightly shake each connector or wiring harness vertically and horizontally while monitoring the PID.
- If the PID value is unstable, check for a poor connection.
  
  Fig 1: Inspecting Wiring Harnesses
  Courtesy of MAZDA MOTORS CORP.