LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2006 >> 6 s, 4D Wagon, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (On-Board Diagnostic [Engine Control System L3)) >> On-Board Diagnostic Test >> Diagnostic Monitoring Test Results Access Procedure

Diagnostic Monitoring Test Results Access Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Perform the necessary vehicle preparation and visual inspection.
  2. Connect WDS or equivalent to the vehicle DLC-2 16-pin connector located at the left side of the center console.
  3. Access to the DIAGNOSTIC MONITORING TEST RESULTS and read the test results by WDS or equivalent.
    Fig 1: Locating DLC-2 Connector
    G04324072Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals