LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2006 >> 6 s, 4D Wagon, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (On-Board Diagnostic [Engine Control System L3)) >> DTC P0462 >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different variant/trim than selected.
DTC P0462 DIAGNOSTIC PROCEDURE

STEP INSPECTION ACTION
1 VERIFY FREEZE FRAME DATA HAS BEEN RECORDED 
  • Has FREEZE FRAME DATA been recorded?
 Yes Go to the next step.
No Record FREEZE FRAME DATA on repair order, then go to the next step.
2 VERIFY RELATED REPAIR INFORMATION AVAILABILITY 
  • Check for related Service Bulletins and/or on-line repair information availability.
  • Is any related repair information available?
 Yes Perform repair or diagnosis according to the available repair information.
  • If the vehicle is not repaired, go to the next step.
No Go to the next step.
3 INSPECT INSTRUMENT CLUSTER 
 Yes Repair or replace suspected malfunction, then go to Step 4.
No Go to the next step.
4 VERIFY TROUBLESHOOTING OF DTC P0462 COMPLETED 
  • Make sure to reconnect all disconnected connectors.
  • Turn ignition switch to ON (Engine off).
  • Clear the DTC from the memory using the WDS or equivalent.
  • Start the engine.
  • Is PENDING CODE for this DTC present?
 Yes Replace PCM, then go to the next step.
No Go to the next step.
5 VERIFY AFTER REPAIR PROCEDURE 
 Yes Go to the applicable DTC inspection.
(See DTC TABLE ).
No Troubleshooting completed.
scientia non olet · About LEMON Manuals