No.2 Abs Warning Light Or Brake System Warning Light Stays On More Than 4 Seconds With Ignition Switch On: Notes
- When performing an asterisk (*) troubleshooting inspection, shake the wiring harness and connectors while doing the inspection to discover whether poor contact points are the cause of any intermittent malfunctions. If there is a problem, check to make sure connectors, terminals and wiring harness are connected correctly and undamaged.NO.2 ABS WARNING LIGHT OR BRAKE SYSTEM WARNING LIGHT STAYS ON MORE THAN 4 SECONDS WITH IGNITION SWITCH ON - TROUBLESHOOTING HINTS
2 ABS warning light or BRAKE system warning light stays on more than 4 seconds with ignition switch on. [TROUBLESHOOTING HINTS] - ABS HU/CM detects ABS system malfunction
- ABS HU/CM detects low voltage in power supply (ABS HU/CM ignition terminal Z voltage is below about 9.4 V or above about 17.4 V)
- ABS HU/CM does not operate
- ABS warning light circuit shorted to ground
- BRAKE system warning light circuit shorted to ground