Flywheel Housing To Block Dowel Removal/Installation
WARNING: This page is about a different variant/trim than selected.
NOTE:
- Take care not to damage the flywheel housing to block dowel holes or the surface areas around the flywheel housing to block dowel hole during removal.
- Remove the flywheel housing to block dowels using a drift pin where the flywheel housing to block dowel is installed in an open hole and a pair of locking pliers where the flywheel housing to block dowel is installed in a blind hole.NOTE:
- Care should be taken to drive the flywheel housing to block dowel squarely into place until it is fully seated without damaging the surrounding surface areas.
- Install all flywheel housing to block dowels by driving them into place using a brass or plastic mallet.