Muffler Inlet Pipe Removal/Installation - 3.0L

WARNING: This page is about a different car, the 2005 Mazda B3000. However, it is still accessible from the selected car via links, so may be relevant.

Raise the vehicle on a hoist. See LIFTING .
Remove the bolts.
Remove the exhaust inlet pipe nuts and gasket.
Position the exhaust inlet pipe and install the bolts.
Tightening torque

34-46 N.m { 3.47-4.69 kgf.m, 25-33 ft.lbf}
Install a new exhaust inlet pipe gasket and install the nuts.

Fig 1: Installing Exhaust Inlet Pipe Gasket Nuts - With Torque Specification
Courtesy of MAZDA MOTORS CORP.
Lower the vehicle.