LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2005 >> B4000 SE, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 165 (Air Bag System) >> Removal & Installation >> Side Crash Sensor >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 2004 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before proceeding, see AIR BAG SAFETY PRECAUTIONS  . Disable air bag system. See DISABLING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM.
  2. Partially peel back caps on appropriate assist handle and remove screws and assist handle. Remove front and scuff plates. Remove the power sliding door rear switch, if equipped. Turn seaming welt over. Remove fastener, and using appropriate tool, disengage clips and remove B-pillar lower trim.
  3. Remove nut, disconnect electrical connector and remove side crash sensor. See Fig 1 . Remove bolt and side crash sensor bracket.
  4. To install, reverse removal procedure. Tighten nut and bolts to specification. See TORQUE SPECIFICATIONS  . Activate air bag system. See ACTIVATING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM.
Fig 1: Identifying Side Crash Sensor
G99E30951Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals