LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2005 >> B4000 SE, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Engine Mechanical) >> Removal & Installation >> Intake Manifold >> Installation (Lower)

Installation (Lower)

WARNING: This page is about a different car, the 2002 Mazda B3000 and 2001 Mazda B3000. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lightly oil all retaining bolts and stud threads before installation. Apply silicone sealer onto 4 intersecting corners of cylinder block and cylinder head. Install front and rear intake manifold seals. Position lower intake manifold gaskets into place with locking tabs over tabs on cylinder head gaskets.
  2. Carefully install lower intake manifold. Install manifold retaining bolts and tighten in sequence to specification. See Fig 1. See TORQUE SPECIFICATIONS .
  3. Install No. 3 cylinder intake valve push rod. Rotate crankshaft until No. 3 intake push rod is at its lowest point on camshaft lobe. Position rocker arm on valve and tighten rocker arm bolt to specification. See TORQUE SPECIFICATIONS . To complete installation, reverse removal procedure.
Fig 1: Lower Intake Manifold Tightening Sequence
G00040520Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals