LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2005 >> B4000 SE, Automatic >> Repair and Diagnosis >> Engine Mechanical >> Lubrication System >> Engine Mechanical [Lubrication System 4.0L) >> Oil Pressure Sensor Removal/Installation - 4.0L

Oil Pressure Sensor Removal/Installation - 4.0L

  1. Disconnect the battery ground cable.
  2. Disconnect the engine control sensor wiring from the oil pressure sensor.
    Fig 1: Disconnecting Engine Control Sensor Wiring From Oil Pressure Sensor
    G03728786Courtesy of MAZDA MOTORS CORP.
  3. Remove the oil pressure sensor.
  4. To install, reverse the removal procedure.
    1. Apply sealant to oil pressure sender threads.
      Fig 2: Installing Oil Pressure Sensor (4.0L)
      G03728787Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals