Intermediate Shaft Speed (ISS) Sensor Removal/Installation

WARNING: This page is about a different variant/trim than selected.

Raise and support the vehicle; see JACKING .
Disconnect intermediate shaft speed (ISS) sensor electrical connector.

Fig 1: Identifying Intermediate Shaft Speed (ISS) Sensor Electrical Connector
Courtesy of MAZDA MOTORS CORP.
Remove ISS sensor.
1. Remove the screw.
2. Remove the ISS sensor from the transmission.
3. Inspect the ISS sensor O-ring for damage. If damaged, install a new O-ring.
  
  Fig 2: Removing ISS Sensor
  Courtesy of MAZDA MOTORS CORP.
Inspect and lubricate O-ring with petroleum jelly.
1. Install the ISS sensor into the transmission.
2. Tighten the ISS sensor screw.
  
  Fig 3: Installing ISS Sensor - With Torque Specification
  Courtesy of MAZDA MOTORS CORP.
Connect OSS sensor electrical connector.

Fig 4: Connecting OSS Sensor Electrical Connector
Courtesy of MAZDA MOTORS CORP.
Lower the vehicle.