Turn Signal/Hazard Lamp Is Inoperative

PINPOINT TEST 2 - TURN SIGNAL/HAZARD LAMP IS INOPERATIVE

PINPOINT TEST 2		ONE TURN SIGNAL/HAZARD LAMP IS INOPERATIVE
STEP	INSPECTION		ACTION
1	CHECK THE STOPLAMPS Press and release the brake pedal while observing the rear lamps. Do the stoplamps operate correctly?	Yes	Go to step 2.
1		No	REFER to Stoplamps, See SYMPTOM TROUBLESHOOTING CHART - STOPLAMP .
2	CHECK THE GROUND CIRCUIT FOR AN OPEN Key OFF. Place the headlamp switch to the parking lamps ON position and observe the inoperative turn lamp. Does the parking lamp illuminate?	Yes	Go to step 3.
2		No	Repair circuit B. Test the system for normal operation.
3	CHECK THE MULTIFUNCTION SWITCH Carry out the multifunction switch component test. See MULTI-FUNCTION SWITCH - COMPONENT TEST . Is the multifunction switch OK?	Yes	For LH front parking/turn lamp, Repair circuit LG/W. Test the system for normal operation. For RH front parking/turn lamp, Repair circuit W/LB. Test the system for normal operation.
3		No	Replace the multifunction switch. See MULTI-FUNCTION SWITCH REMOVAL/INSTALLATION .