Brake Shoes &/Or Pads: Remove & Replace
Includes: Clean, lube and/or replace Brake Hardware as necessary. Adjust Brakes (where applicable). Includes: Repack Wheel Bearings (where applicable). DOES NOT include refinishing.| Applies To | Note | Standard Hours | Warranty Hours | Skill Level |
|---|---|---|---|---|
| All,Both Axles | 2.2 | B | ||
| Front,Both Sides | 1.0 | B | ||
| Rear,Both Sides | 1.4 | B | ||
| Combination Procedure: CALIPER: Replace: | ||||
| One | Includes: Bleed Brakes. | 0.7 | B | |
| Combination Procedure: DISC ROTOR: Remove and Install for Refinishing: NOTE: This operation does not apply to front rotors on FWD vehicles or rear rotors on RWD vehicles. If on vehicle refinishing is not possible use appropriate repair operation. | ||||
| Front,Each | 0.3 | B | ||
| Combination Procedure: DISC ROTOR: Replace: | ||||
| Front | Includes: Repack Wheel Bearings. | 0.4 | B | |
| Combination Procedure: DRUM: Replace: | ||||
| Each | 0.1 | B | ||
| Combination Procedure: WHEEL BEARING: Repack: | ||||
| Front,Both Sides | 0.8 | B | ||
| Combination Procedure: WHEEL BEARING: Replace: | ||||
| Front,Each Side | 0.5 | B | ||
| Combination Procedure: WHEEL CYLINDER: Replace: | ||||
| One | 0.8 | B | ||
| Combination Procedure: WHEEL SEAL: Replace: | ||||
| Rear,Both Sides | 0.8 | B | ||
| Rear,Each Side | 0.6 | B | ||