Rear Crankshaft Main Bearing Seal: Service and Repair
REAR OIL SEAL REPLACEMENT1. Remove the flywheel. (MTX)
2. Remove the drive plate. (ATX)
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
Rear Oil Seal Installation Note
1. Apply silicone sealant to the mating faces as shown in the figure.
Caution: Install the rear oil seal within 10 min of applying the silicone sealant.
Thickness 4.0 - 6.0 mm (0.16 - 0.23 inch)
2. Apply clean engine oil to the new oil seal lip.
3. Install the rear oil seal using the installer as shown in the figure.
4. Tighten the rear oil seal bolts in the order as shown in the figure.
Tightening torque 8.0 - 11.5 Nm (81.6 - 117.2 kgf-cm, 70.9 - 101.7 inch lbs.)