LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2004 >> RX-8 1.3 3 >> Repair and Diagnosis >> External Pages >> Different car >> Section 84 (Air Bag System) >> Disposal Procedures >> On-Vehicle Deployment (Scrapped Vehicle) (Seats Installed) >> Seat Belt Pretensioner (Seats Installed)

Seat Belt Pretensioner (Seats Installed)

WARNING: This page is about a different car, the 2003 Mazda Tribute. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before deploying seat belt pretensioner, inspect operating condition of Deployment Tool (49 H066 002). See INSPECTING DEPLOYMENT TOOL  under DISPOSAL PROCEDURES. Ensure vehicle is outside and away from other vehicles and people. Disable air bag system, See DISABLING & ACTIVATING AIR BAG SYSTEM  .
  2. Access and disconnect appropriate seat belt pretensioner harness connector. Connect deployment tool connector "A" to seat belt pretensioner connector. See Figure . Close all doors and windows. Connect Red clip of deployment tool to positive battery terminal and Black clip of deployment tool to negative battery terminal. Verify deployment tool Red light is on.
  3. Ensure all persons are at least 20 feet (6 m) from vehicle. Press deployment tool activation switch to deploy seat belt pretensioner. Because of heat generated from seat belt pretensioner deployment, wait at least 15 minutes before handling deployed seat belt pretensioner.
scientia non olet · About LEMON Manuals