LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2004 >> RX-8 1.3 3 >> Repair and Diagnosis >> External Pages >> Different car >> Section 55 (Engine Controls [Basic Diagnostic Procedures]) >> Fuel System >> Fuel Pressure (B2300, B3000, B4000 & Tribute) >> Fuel Pressure Regulator Inspection (Tribute Only)

Fuel Pressure Regulator Inspection (Tribute Only)

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2003 Mazda Tribute, 2003 Mazda Protege5, 2003 Mazda Protege, 2003 Mazda MX-5 Miata, and 2003 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.

  1. Check Fuel Pressure

    Release fuel pressure. See FUEL PRESSURE RELEASE . Install Fuel Pressure Gauge (49-UN01-010). Start engine and run at idle. Disconnect vacuum hose from fuel pressure regulator and plug it. Drive vehicle under heavy acceleration while observing fuel pressure gauge reading. If fuel pressure holds steady within 3 psi (20.6 kPa), go to next step. If fuel pressure does not hold to within 3 psi (20.6 kPa), check fuel vapor valve. See SYSTEM TESTS (EVAPORATIVE EMISSION) in SYSTEM & COMPONENT TESTING - B2300, B3000, B4000 & TRIBUTE article. If fuel vapor valve is okay, check for clogged fuel filter.

  2. Check Fuel Pressure With Vacuum Applied To Regulator

    Connect vacuum pump to fuel pressure regulator. Apply vacuum to fuel pressure regulator. If fuel line pressure decreases when vacuum is applied, check vacuum hose and vacuum source. Repair as necessary. After repair, go to next step. If fuel pressure does not decrease when vacuum is applied, replace fuel pressure regulator. After repair, go to step  4.

  3. Check Fuel Pressure And Verify Fuel Flow

    Disconnect fuel return line from fuel rail. Connect a short hose from fuel rail to a one quart (one liter) measuring container. Turn ignition on, engine off. Connect scan tool to DLC. Select DIAGNOSTIC DATA LINK. Select PCM. Select ACTIVE COMMAND MODE. Select OUTPUT TEST MODE and FUEL PUMP PID. Press MODE to change to ALL ON MODE. Press START to run fuel pump. Measure fuel line pressure and verify fuel is flowing into container. If fuel pressure is still high, replace fuel pressure regulator. Restore vehicle to original condition. If fuel pressure is not high, inspect fuel return line for blockage or clog. Repair or replace as necessary. After repair, go to next step.

  4. Check Regulator For Fuel Leaks

    Start engine and run at idle for 10 seconds. Turn ignition off for 10 seconds. Start engine and run at idle for 10 seconds. Turn ignition off. Disconnect vacuum hose from pressure regulator. If diaphragm is leaking fuel, replace fuel pressure regulator. Restore vehicle to original condition. If fuel is not leaking from diaphragm, restore vehicle to original condition. Testing is complete.
scientia non olet · About LEMON Manuals