LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2004 >> RX-8 1.3 3 >> Repair and Diagnosis >> External Pages >> Different car >> Section 328 (Air Bag System) >> Air Bag Module And Pre-TENSIONER Seat Belt Deployment Procedures >> Deployment Procedure for Inside of Vehicle (Only When Vehicle Is To Be Scrapped) >> Side air bag module

Side air bag module

WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the side air bag module connector.
  2. Connect the SST  (Adapter harness) to the side air bag module.
    Fig 1: Connecting SST (Adapter Harness) To Side Air Bag Module
    G03645139Courtesy of MAZDA MOTORS CORP.
  3. Connect the SST  (Deployment tool) to the SST  (Adapter harness).
  4. Connect the red clip of the SST  (Deployment tool) to the positive battery terminal and the black clip to the negative battery terminal.
  5. Verify that the red light on the SST  (Deployment tool) is illuminated.
  6. Make sure all persons are standing at least 6 m {20 ft}  from the vehicle.
    Fig 2: Connecting SST (Adapter Harness) To SST (Deployment Tool)
    G03645140Courtesy of MAZDA MOTORS CORP.
  7. Press the activation switch on the SST  (Deployment tool) to deploy the side air bag module.
    Fig 3: Locating Activation Switch
    G03645141Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals