LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2004 >> RX-8 1.3 3 >> Repair and Diagnosis >> External Pages >> Different car >> Section 308 (Drive Shaft) >> Joint Shaft Disassembly/Assembly [L3] >> Bearing Disassembly Note >> When the bearing remains on the bracket

When the bearing remains on the bracket

WARNING: This page is about a different car, the 2005 Mazda 6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the bearing and the dust seals (both differential side and wheel side) using the SSTs  .
    Fig 1: Removing Bearing And Dust Seals Using SST
    G03644385Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals