LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2004 >> RX-8 1.3 3 >> Repair and Diagnosis >> External Pages >> Different car >> Section 3 (Engine Controls - Removal, Overhaul & Installation) >> Engine Sensors & Switches >> Crankshaft Position Sensor >> Removal & Installation (Miata & Protege 1.6L)

Removal & Installation (Miata & Protege 1.6L)

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2001 Mazda Tribute, 2001 Mazda Protege, 2001 Mazda Millenia, 2001 Mazda MX-5 Miata, and 2001 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect negative battery cable. Sensor is located on front of engine, near crankshaft pulley. Remove engine undercover. Disconnect wiring connector. Remove sensor bolts and sensor. To install, replace sensor and loosely install mounting bolts. Using a feeler gauge, adjust sensor air gap to.020-.060" (.5-1.5 mm). On Protege models, only some adjustment is possible. If air gap is still not within specification, replace crankshaft pulley. To complete installation, reverse removal procedure. Tighten bolts to specification. See TORQUE SPECIFICATIONS 

scientia non olet · About LEMON Manuals