Removal & Installation (Miata)
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Mazda Tribute, 2002 Mazda Protege5, 2002 Mazda Protege, 2002 Mazda Millenia, and 2002 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
Disconnect negative battery cable. Crankshaft Position (CKP) sensor is located on front of engine, near crankshaft pulley. Remove engine compartment undercover. Disconnect CKP sensor harness connector. Remove bolts and CKP sensor. To install, replace CKP sensor and loosely install mounting bolts. Using a feeler gauge, adjust sensor air gap to .020-.059" (.5-1.5 mm). If air gap is still not within specification, replace crankshaft pulley or CKP sensor. To complete installation, reverse removal procedure. Tighten bolts to specification. See TORQUE SPECIFICATIONS .