LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2004 >> RX-8 1.3 3 >> Repair and Diagnosis >> External Pages >> Different car >> Section 29 (Engine Controls - Removal, Overhaul & Installation) >> Engine Sensors & Switches >> Camshaft Synchronizer (B3000) >> Removal

Camshaft Synchronizer (B3000): Removal

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Mazda Tribute, 2002 Mazda Protege5, 2002 Mazda Protege, 2002 Mazda Millenia, and 2002 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position crankshaft to TDC of cylinder No. 1, on compression stroke. Note position of electrical connector on CMP sensor.
  2. Disconnect negative battery cable. Unplug harness connector from CMP sensor. Remove CMP sensor screws and CMP sensor from positioner. See Figure. Remove synchronizer hold-down bolt and CMP synchronizer.
CAUTION: Do not rotate crankshaft while synchronizer is removed from engine.
scientia non olet · About LEMON Manuals