Removal & Installation (B3000)
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Mazda Tribute, 2002 Mazda Protege5, 2002 Mazda Protege, 2002 Mazda Millenia, and 2002 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
Camshaft Position (CMP) sensor is located on rear of engine, behind intake manifold. See Fig 1. Before removing, note position of harness connector on CMP sensor. Disconnect negative battery cable. Remove upper intake manifold. See REMOVAL (B3000) under UPPER INTAKE MANIFOLD. Disconnect CMP sensor harness connector. Remove CMP sensor screws and CMP sensor. To install, reverse removal procedure. Ensure CMP sensor harness connector is pointing in original direction. Tighten CMP sensor to specification. See TORQUE SPECIFICATIONS .