LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2004 >> RX-8 1.3 3 >> Repair and Diagnosis >> External Pages >> Different car >> Section 20 (Engine Controls - On-Vehicle Adjustments) >> Idle Speed & Mixture >> Idle Speed >> Miata, Millenia, Protege & Protege5

Miata, Millenia, Protege & Protege5

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Mazda Tribute, 2002 Mazda Protege5, 2002 Mazda Protege, 2002 Mazda Millenia, and 2002 Mazda MX-5 Miata. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect NGS scan tool to DLC-2 located under left side of instrument panel:
    • Miata, Protege and Protege5 - Left of steering column
    • Millenia - Right of steering column

    See Figure or Figure . Connect a jumper wire between terminals TEN and GND at DLC-1 in engine compartment. See Figure .

  2. Start engine and allow it to idle. Turn off all electrical loads. Using NGS scan tool, select PID/DATA MONITOR AND RECORD and monitor RPM. If idle speed is not within specification, rotate Air Adjusting Screw (AAS) on throttle body. See Figure -Figure . See IDLE SPEED SPECIFICATIONS  table.
scientia non olet · About LEMON Manuals