LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2004 >> RX-8 1.3 3 >> Repair and Diagnosis >> External Pages >> Different car >> Section 116 (Rear Suspension System) >> Rear Suspension >> Wheel Bearing - 2WD >> Installation

Wheel Bearing - 2WD: Installation

WARNING: This page is about a different car, the 2004 Mazda Tribute, 2003 Mazda Tribute, and 2002 Mazda Tribute. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using the special tools, install the wheel bearing into the wheel knuckle.
    Fig 1: Installing Wheel Bearing Onto Wheel Knuckle
    G01150502Courtesy of MAZDA MOTORS CORP.
  2. Install the snap ring.
    Fig 2: Installing Snap Ring
    G01150503Courtesy of MAZDA MOTORS CORP.
  3. Using the special tool, install the wheel hub into the wheel bearing.
    Fig 3: Installing Wheel Hub Into Wheel Bearing
    G01150504Courtesy of MAZDA MOTORS CORP.
  4. Install the wheel hub nut.
    Fig 4: Installing Wheel Hub Nut
    G01150505Courtesy of MAZDA MOTORS CORP.
  5. Install the brake drum.
scientia non olet · About LEMON Manuals