LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2004 >> RX-8 1.3 3 >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> Engine Mechanical (Service Information) >> Rear Oil Seal Replacement >> Rear Oil Seal Installation Note

Rear Oil Seal Installation Note

  1. Apply engine oil to the lip of a new rear oil seal.
  2. Tap the rear oil seal evenly in the stationary gear using the SST  .
    CAUTION:
    • Insert until it is attached to the seating face.
    • Do not damage the oil seal lip by catching it on the eccentric shaft and the key.
    Fig 1: Installing Rear Oil Seal In Stationary Gear
    G01345642Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals