LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2004 >> RX-8 1.3 3 >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Cooling System (Mechanical) >> Specifications & Drive Belt Routing >> Adjustments >> Drive Belts >> Adjusting A/C Drive Belt

Adjusting A/C Drive Belt

NOTE: Letters in parenthesis refer to letters in figures.
  1. Remove the engine cover.
  2. Loosen idle pulley lock nut (A). See Fig 1 .
  3. Adjust the drive belt deflection or tension by turning adjusting bolt (B) to the specification. See BELT DEFLECTION SPECIFICATIONS  or BELT TENSION SPECIFICATION  table. See Figure .
  4. Tighten idle pulley lock nut (A) to the specified torque. See TORQUE SPECIFICATIONS  .
  5. Crank the engine and measure the deflection and tension again. If not within the specification, repeat from step  2 again. Install the engine cover.
Fig 1: Adjusting A/C Belt
G00315314Courtesy of MAZDA MOTOR CO.
scientia non olet · About LEMON Manuals