SAS Control Module: Installation
WARNING: This page is about a different car, the 2003 Mazda Protege5 and 2003 Mazda Protege. However, it is still accessible from the selected car via links, so may be relevant.
- To install, reverse removal procedure. Ensure that SAS control module is installed with arrow pointing toward front of vehicle. Tighten fasteners to specification. See TORQUE SPECIFICATIONS .
- After SAS control module is installed, activate air bag system. Check AIR BAG warning light to ensure system is functioning properly. See SYSTEM OPERATION CHECK . If a new SAS control module is being installed, go to next step.
- Verify that AIR BAG warning light flashes continuously approximately 6 seconds after ignition is turned to ON position. Turn ignition off. Wait at least one second and turn ignition on. Ensure AIR BAG warning light does not flash continuously after approximately 6 seconds.
- If procedure is performed correctly, AIR BAG warning light should come on and then turn off after approximately 6 seconds. If AIR BAG warning light does not turn off, repeat step 3.