Transaxle Fluid Temperature (TFT) Sensor Removal/Installation
WARNING: This page is about a different car, the 2003 Mazda Protege5 and 2003 Mazda Protege. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
- When the transaxle and ATF are hot, they can badly burn. Turn off the engine and wait until they are cool before performing this procedure.
- Remove the oil pan. (See ON-VEHICLE REMOVAL .)
- Disconnect the TFT sensor connector.
- Remove the TFT sensor.
- Install a new TFT sensor.
- Connect the TFT sensor connector.
- Install the oil pan. (See ON-VEHICLE INSTALLATION .)
- Carry out the mechanical system test. (See MECHANICAL SYSTEM TEST .)