O/D Off Switch Removal/Installation (4AT)
WARNING: This page is about a different car, the 2003 Mazda Protege5 and 2003 Mazda Protege. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect the negative battery cable.
- Remove the center console.
- Remove the selector lever nuts.
- Disconnect the connector and remove the O/D OFF switch terminals. (See CONNECTOR DISASSEMBLY NOTE .)
- Remove the selector lever knob component.
- Install a new selector lever knob component.
Tightening Torque
2.0-2.9 N.m {20-30 kgf.cm, 18-26 in.lbf}
- Install the selector lever nuts.
Tightening Torque
16-22 N.m {1.6-2.3 kgf.m, 12-16 ft.lbf}
- Install the O/D OFF switch terminals and connect the connector.
- Install the center console.
- Connect the negative battery cable.