Inspection Of Continuity

WARNING: This page is about a different car, the 2003 Mazda Protege5 and 2003 Mazda Protege. However, it is still accessible from the selected car via links, so may be relevant.

Inspect for continuity at the O/D OFF switch.
- If the switch is okay, inspect the wiring harness. (O/D OFF switch - PCM, O/D OFF switch - Body ground)
- If not as specified, replace the selector lever knob component. (See SELECTOR LEVER DISASSEMBLY/ASSEMBLY .)
  
  Fig 1: Position And Connector Terminal Specification
  Courtesy of MAZDA MOTORS CORP.
  
  Fig 2: Measuring Continuity At O/D Off Switch
  Courtesy of MAZDA MOTORS CORP.