Transaxle Installation Note

WARNING: This page is about a different car, the 2003 Mazda Protege5 and 2003 Mazda Protege. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Do not allow the transaxle to fall from the jack.

Set the transaxle on a jack and lift it.
Install the transaxle mounting bolts.

Fig 1: Installing Transaxle Mounting Bolts
Courtesy of MAZDA MOTORS CORP.

Tightening Torque

A: 64-89 N.m {6.5-9.1 kgf.m, 48-65 ft.lbf}

B: 90-116 N.m {9.1-11.9 kgf.m, 66-86 ft.lbf}

C: 38-51 N.m {3.8-5.3 kgf.m, 28-38 ft.lbf}

D: 19-25 N.m {1.9-2.6 kgf.m, 14-18 ft.lbf}
Tighten the SST (49 E017 5A0) so that the engine is located at the specified position.

Fig 2: Identifying Bolts Tightening Torque
Courtesy of MAZDA MOTORS CORP.