Rear Antenna Feeder Inspection: 5HB

WARNING: This page is about a different car, the 2003 Mazda Protege5 and 2003 Mazda Protege. However, it is still accessible from the selected car via links, so may be relevant.

Remove the rear antenna feeder.
Verify that there is no continuity between rear antenna feeder terminals A and B using an ohmmeter.
Inspect for continuity between the rear antenna feeder terminals using an ohmmeter.
- If not as specified, replace the rear antenna feeder.
Fig 1: Inspecting Rear Antenna Feeder Continuity (1 Of 2)
Courtesy of MAZDA MOTORS CORP.

Fig 2: Inspecting Rear Antenna Feeder Continuity (2 Of 2)
Courtesy of MAZDA MOTORS CORP.