LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2003 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 308 (Entertainment System) >> Rear Antenna Feeder Inspection >> 4SD

Rear Antenna Feeder Inspection: 4SD

WARNING: This page is about a different car, the 2003 Mazda Protege5 and 2003 Mazda Protege. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear antenna feeder.
  2. Verify that there is no continuity between rear antenna feeder terminals A and B using an ohmmeter.
  3. Verify that there is continuity between rear antenna feeder terminals B and D using an ohmmeter.
  4. Verify that there is no continuity between rear antenna feeder terminals A and C using an ohmmeter.
    • If not as specified, replace the rear antenna feeder.
    NOTE:
    • The condenser is installed between terminals A and C of the antenna feeder.
    Fig 1: Inspecting Rear Antenna Feeder Continuity
    G01915504Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals