LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2003 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 308 (Entertainment System) >> Front Antenna Feeder Inspection

Front Antenna Feeder Inspection

WARNING: This page is about a different car, the 2003 Mazda Protege5 and 2003 Mazda Protege. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the audio unit. (See AUDIO UNIT REMOVAL  .) (See AUDIO UNIT INSTALLATION  .)
  3. Remove the driver-side front side trim. (See FRONT SIDE TRIM REMOVAL/INSTALLATION .)
  4. Disconnect the connection between the pillar antenna and the front antenna feeder.
  5. Verify that there is no continuity between the front antenna feeder terminals A and B using an ohmmeter.
    • If not as specified, replace the front antenna feeder.
  6. Inspect for continuity between the front antenna feeder terminals using an ohmmeter.
    • If not as specified, replace the front antenna feeder.
    Fig 1: Inspecting Front Antenna Feeder Continuity (1 Of 2)
    G01915498Courtesy of MAZDA MOTORS CORP.
    Fig 2: Inspecting Front Antenna Feeder Continuity (2 Of 2)
    G01915499Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals