Washer Fluid-Level Sensor Removal/Installation

WARNING: This page is about a different car, the 2003 Mazda Protege5 and 2003 Mazda Protege. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the negative battery cable.
Remove the washer tank. (See WASHER TANK REMOVAL/INSTALLATION .)
Remove in the order indicated in the table.

Fig 1: Washer Fluid-Level Sensor Removing Sequence Index
Courtesy of MAZDA MOTORS CORP.

Fig 2: Removing Sequence Of Washer Fluid-Level Sensor
Courtesy of MAZDA MOTORS CORP.
Install in the reverse order of removal.