Washer Fluid-Level Sensor Inspection

WARNING: This page is about a different car, the 2003 Mazda Protege5 and 2003 Mazda Protege. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the negative battery cable.
Remove the washer tank. (See WASHER TANK REMOVAL/INSTALLATION .)
Inspect for continuity between the washer fluid-level sensor terminals using an ohmmeter.
- If not as specified, replace the washer fluid-level sensor.
Fig 1: Washer Fluid-Level Sensor Terminals Continuity Reference
Courtesy of MAZDA MOTORS CORP.

Fig 2: Inspecting For Continuity Between Washer Fluid-Level Sensor Terminals
Courtesy of MAZDA MOTORS CORP.