LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2003 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 305 (Interior Trim) >> Tire House Trim Removal/Installation >> 4SD

Tire House Trim Removal/Installation: 4SD

WARNING: This page is about a different car, the 2003 Mazda Protege5 and 2003 Mazda Protege. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear seat back.
  2. Remove the rear scuff plate.
  3. Remove the rear package trim.
  4. Remove the lower anchor installation bolt from the rear seat belt.
  5. Remove the fasteners.
  6. Pull the tire house trim forward, then remove the tire house trim.
    Fig 1: Removing Tire House Trim (4SD)
    G01915306Courtesy of MAZDA MOTORS CORP.
  7. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals