Side Protector Removal

WARNING: This page is about a different car, the 2003 Mazda Protege5 and 2003 Mazda Protege. However, it is still accessible from the selected car via links, so may be relevant.

Pry the side protector end 20-30 mm (0.8-1.1 in) using a Flathead screwdriver or a razor.
WARNING:
- Using a razor with bare hands can cause injury. Always wear gloves when using a razor.
Pull the side protector toward you, then remove it.

Fig 1: Prying Side Protector End Using Flathead Screwdriver Or Razor
Courtesy of MAZDA MOTORS CORP.
NOTE:
- The side protector is installed with double-sided adhesive tape. If the side protector is difficult to remove, soften the double-sided adhesive tape using a hot air blower.