Reusing Rear Window Glass

WARNING: This page is about a different car, the 2003 Mazda Protege5 and 2003 Mazda Protege. However, it is still accessible from the selected car via links, so may be relevant.

Use an awl to saw through the sealant, except where there are fasteners and spacers, from the inside of the vehicle.

Fig 1: Identifying Fasteners And Spacers
Courtesy of MAZDA MOTORS CORP.
Pass the SST (piano wire) through the hole.
WARNING:
- Using a SST (piano wire) with bare hands can cause injury. Always wear gloves when using a SST (piano wire).
Wind each end of the SST (piano wire) around a bar.

Fig 2: Applying Protective Tape
Courtesy of MAZDA MOTORS CORP.
Working with another person, saw through the sealant around the edge of the glass, being careful not to damage the body.
NOTE:
- Use a long sawing action to spread the work over the whole length of the SST (piano wire) to prevent it from breaking.
Remove the rear window glass.

Fig 3: Removing Rear Window Glass
Courtesy of MAZDA MOTORS CORP.
Remove the pins, fasteners and spacers.
Remove the rear window molding from the rear window glass.

Fig 4: Removing Fasteners And Spacers
Courtesy of MAZDA MOTORS CORP.