Power Window SUBSWITCH Inspection

WARNING: This page is about a different car, the 2003 Mazda Protege5 and 2003 Mazda Protege. However, it is still accessible from the selected car via links, so may be relevant.

If inspecting the passenger's side, remove the switch panel.
If inspecting the rear, remove the power window subswitch.
Inspect for continuity between the power window subswitch terminals using an ohmmeter.
- If not as specified, replace the power window subswitch.
Fig 1: Inspecting Power Window Subswitch - Passenger's Side (1 Of 2)
Courtesy of MAZDA MOTORS CORP.

Fig 2: Inspecting Power Window Subswitch - Passenger's Side (2 Of 2)
Courtesy of MAZDA MOTORS CORP.

Fig 3: Inspecting Power Window Subswitch - Rear (1 Of 2)
Courtesy of MAZDA MOTORS CORP.

Fig 4: Inspecting Power Window Subswitch - Rear (2 Of 2)
Courtesy of MAZDA MOTORS CORP.