LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2003 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 298 (Seat Belt System) >> Seat Belt Inspection >> ELR

Seat Belt Inspection: ELR

WARNING: This page is about a different car, the 2003 Mazda Protege5 and 2003 Mazda Protege. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify that the belt can be pulled out smoothly, and that it moves smoothly when wound.
    • If not as specified, replace the seat belt.
  2. Verify that the retractor locks when the belt is pulled quickly.
    • If not as specified, replace the seat belt.
  3. Remove the retractor. (See FRONT SEAT BELT REMOVAL/INSTALLATION  .) (See REAR SEAT BELT REMOVAL/INSTALLATION  .) (See REAR CENTER SEAT BELT REMOVAL/INSTALLATION  .) 4. Hold the retractor as it would be installed.
  4. Slowly incline the retractor while pulling out the belt.
    Fig 1: Inspecting Seat Belt
    G01914880Courtesy of MAZDA MOTORS CORP.
  5. Verify that the retractor locks at approximately 30°  inclination.
    • If not as specified, replace the seat belt.
    Fig 2: Identifying Retractor Locking Position
    G01914881Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals