LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2003 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 293 (Power Steering System) >> Steering Gear And Linkage Reassembly >> Mounting Rubber Assembly Note

Mounting Rubber Assembly Note

WARNING: This page is about a different car, the 2003 Mazda Protege5 and 2003 Mazda Protege. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply soapy water to the rubber part of the mounting rubber.
  2. Press the mounting rubber until the mounting rubber end comes out completely from the gear housing using the SSTs  and a press.
    NOTE:
    • Mounting rubber end and steel plate shall be aligned.
    Fig 1: Assembling Mounting Rubber (1 Of 2)
    G01914588Courtesy of MAZDA MOTORS CORP.
  3. Reverse the gear housing, then press the mounting rubber until the mounting rubber end comes completely out the other side.
    Fig 2: Assembling Mounting Rubber (2 Of 2)
    G01914589Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals