Holder Assembly Note

WARNING: This page is about a different car, the 2003 Mazda Protege5 and 2003 Mazda Protege. However, it is still accessible from the selected car via links, so may be relevant.

Apply grease to the U-gasket and O-ring.
Assemble the U-gasket and O-ring into the holder.
Assemble the SST to the steering rack.

Fig 1: Assembling Holder (1 Of 3)
Courtesy of MAZDA MOTORS CORP.
Assemble the holder using the SST.

Fig 2: Assembling Holder (2 Of 3)
Courtesy of MAZDA MOTORS CORP.
Stake the holder to the cylinder using a punch.

Fig 3: Assembling Holder (3 Of 3)
Courtesy of MAZDA MOTORS CORP.