LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2003 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 292 (Automatic Transaxle Shift Mechanism) >> Selector Lever Adjustment

Selector Lever Adjustment

WARNING: This page is about a different car, the 2003 Mazda Protege5 and 2003 Mazda Protege. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the center console.
  2. Shift the selector lever to the P position.
  3. Unlock the lock piece of the selector cable (selector lever side) in the order shown in the figure.
  4. Verify that the manual shaft is at the P position.
    Fig 1: Adjusting Procedure Selector Lever (1 Of 2)
    G01914521Courtesy of MAZDA MOTORS CORP.
  5. Lock the lock piece of the selector cable (selector lever side) in the order shown in the figure.
  6. Install the center console.
  7. Shift the selector lever from P position to 1 range (4AT)/M range (Sport AT), and make sure that there are no other components in that area to interfere with the lever.
    Fig 2: Adjusting Procedure Selector Lever (2 Of 2)
    G01914522Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals