Clutch Pipe Removal/Installation Note

WARNING: This page is about a different car, the 2003 Mazda Protege5, 2003 Mazda Protege, 2002 Mazda Protege5, and 2002 Mazda Protege. However, it is still accessible from the selected car via links, so may be relevant.

When any clutch pipe has been disconnected anytime during the procedure, add brake fluid, bleed the air, and inspect for leakage after the procedure has been completed.
When removing the clutch pipe, remove it using the SST (49 0259 770B). When installing the clutch pipe, change the clutch pipe tightening torque to allow for use of a torque wrench-SST (49 0259 770B) combination, and then tighten the clutch pipe using the SST (49 0259 770B). (See 5 Torque Formulas.)