LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2003 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 289 (On-Board Diagnostic - Automatic Transaxle) >> After Repair Procedure

After Repair Procedure

WARNING: This page is about a different car, the 2003 Mazda Protege5 and 2003 Mazda Protege. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • After repairing a malfunction, perform this procedure to verify that the malfunction has been corrected.
  • When this procedure is carried out, be sure to drive the vehicle at lawful speed and pay attention to the other vehicles.
  1. Connect the WDS or equivalent to the DLC-2.
  2. Turn the ignition key to ON (engine OFF).
  3. Verify that DTCs are cleared from memory.
  4. Decrease ATF temperature to 20 °C {68 °F} or below. 
  5. Start the engine then wait 180 seconds or more. 
  6. Warm up the engine and ATX.
    • Engine coolant temperature: 60 °C {140 °F} or above. 
    • Transaxle fluid temperature: 20 °C {68 °F} or above. 
  7. Shift the selector lever between P position to 1 range (4AT)/M range (Sport AT) while depressing brake pedal.
  8. Drive the vehicle for 150 seconds or more  at a vehicle speed between 25 and 59 km/h {15 and 36 mph},  then 60 km/h {37 mph} or more  for 100 seconds or more. 
  9. Drive the vehicle in D range and shift gears between 1st and 4th (TCC operation) gear.
  10. Gradually slow down and stop the vehicle.
  11. Make sure that the repaired DTC does not recur.
scientia non olet · About LEMON Manuals