LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2003 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 288 (Drive Shaft) >> Joint Shaft Removal/Installation >> Clip Installation Note

Clip Installation Note

WARNING: This page is about a different car, the 2003 Mazda Protege5 and 2003 Mazda Protege. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a new clip onto the joint shaft with the opening facing upward. Ensure that the diameter of the clip does not exceed the specification on installation.
  2. After installation, measure the outer diameter. If it exceeds the specification, repeat steps 1-2 using a new clip.

    Outer diameter specification 

    30.0 mm (1.18 in) 

    Fig 1: Installing New Clip Onto Joint Shaft With Opening Facing Upward
    G01913983Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals