LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2003 >> Tribute LX, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 288 (Drive Shaft) >> Drive Shaft (ZM, FS ATX, FS MTX Right Side And FS With TC Right Side) Disassembly/Assembly >> Boot Assembly Note

Boot Assembly Note

WARNING: This page is about a different car, the 2003 Mazda Protege5 and 2003 Mazda Protege. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fill the boot (wheel side) with the specified grease.
    CAUTION:
    • Do not touch grease with your hand. Apply it from the tube to prevent foreign matter from entering the boot.
    NOTE:
    • The wheel side and transaxle side boots are different.
    • Use the specified grease supplied in the boot kit.
    Fig 1: Grease Specification
    G01914013Courtesy of MAZDA MOTORS CORP.
  2. Install the boot with the splines of the shaft still wrapped in tape from disassembly.
  3. Remove the tape.
scientia non olet · About LEMON Manuals